Selected Publications and Conference Papers (past 5 years) Du Jin, Zhanqiang Liu, Wan Yi, Guosheng Su. Influence of cutting speed on surface integrity for powder metallurgy nickel-based superalloy FGH95. INT J ADV MANUF TECH. 2011, 56:553-559 S. Anurag, Y.B. Guo, Zhanqiang Liu. A new FEM approach to predict residual stress profiles in hard turning without simulating chip formation. Trans. NAMRI/SME, 2010, 38:33-40. Guosheng Su, Zhanqiang Liu. An experimental study on influences of material brittleness on chip morphology. INT J ADV MANUF TECH.2010, 51(1): 87-92. Yinni Cao, Zhanqiang Liu. Signal frequency and parameter estimation for power systems using the hierarchical identification principle. MATH COMPUT MODEL. 2010, 52:854-861. Fang Shao,Zhanqiang Liu,Yi Wan,Finite element simulation of machining of Ti-6Al-4V alloy with thermodynamical constitutive equation. INT J ADV MANUF TECH. 2010, 49(5): 567-578. Fang Shao,Zhanqiang Liu,Yi Wan,Zhenyu Shi. Thermodynamical matching of alumina based composite ceramic tools with typical workpiece materials. INT J ADV MANUF TECH. 2010,49 (5): 431-439. Jihua Wu, Zhanqiang Liu. Modeling of flow stress in orthogonal micro-cutting process based on strain gradient plasticity theory. INT J ADV MANUF TECH. 2010, 46(1-4):143-149. Z. Y. Shi and Zhanqiang Liu. The actual geometry of the cutting tool involved in machining. INT J ADV MANUF TECH. 2010, 46(1-4):91-99. Aijun Tang, Zhanqiang Liu. Three-dimensional stability lobe and maximum material removal rate in end milling of thin-walled plate. INT J ADV MANUF TECH. 2009, 43:33-39 Shijun Zhang, Zhanqiang Liu,A new approach to cutting temperature prediction considering the diffusion layer in coated tools,INT J MACH TOOL MANU. 2009, 49(7-8): 619-624. Z.T. Tang, Zhanqiang Liu, Y.Z. Pan, Y. Wan, X. Ai. The influence of tool flank wear on residual stresses induced by milling aluminum alloy. J MATER PROCESS TECH. 2009, 209(9): 4502-4508. Shijun Zhang, Zhanqiang Liu. Analytical and numerical solutions of transient heat conduction in monolayer coated tools. J MATER PROCESS TECH. 2009,209(5):2369-2376. Shijun Zhang, Zhanqiang Liu. An analytical model for transient temperature distributions in coated carbide cutting tools. INT COMMUN HEAT MASS. 2008,35(10):1311-1315. Tang Aijun, Zhanqiang Liu. Deformations of thin-walled plate due to static end milling force. J MATER PROCESS TECH. 2008,206(1-3): 345-351. |